A problem seems to have arisen with my Martin Fields shield.
[203 byte] By [Jack Hadley] at [2007-11-10 22:53:01] 
On the back of my MF shield it seems dust has gotten under every edge, and is just stuck under it. Did I install my shield poorly? Is this expected to happen? Do any other kinds of these shields do this?
# 1 Re: A problem seems to have arisen with my Martin Fields shield.
Lift the corner up with some tape and then use another bit of tape on the underside to remove the dust.Take a look at the tutorial on the site if you are stuck.
shaneric at 2007-11-15 15:33:31 >
# 2 Re: A problem seems to have arisen with my Martin Fields shield.
This was after a few days of use after I had installed the shield. So I just have to keep cleaning it out whenever dust gets in there?Jack Hadley at 2007-11-15 15:34:31 >
# 3 Re: A problem seems to have arisen with my Martin Fields shield.
get invisibleshield. I don't have any problem!archurban at 2007-11-15 15:35:30 >
# 4 Re: A problem seems to have arisen with my Martin Fields shield.
or 3M scotchgard, works the same way...you just need a little patience to measure and cut it yourself...
i believe its the same product as invisible shield...except a small fraction of the price.
tru5t at 2007-11-15 15:36:24 >
# 5 Re: A problem seems to have arisen with my Martin Fields shield.
I found with my back cover that the side edges seem a little to wide preventing it from wrapping around the curved part of the ipod, thus the reason for dust getting in... either wash the overlay and try again or trim it.Schnake at 2007-11-15 15:37:34 >
[an error occurred while processing this directive]